IP16DS291D-AZ0550 1/2.8" 2MP Sony IMX291 + HI3516D CMOS Module 10X 5-50mm Auto Zoom Lens IR-CUT filter
H.265 video compressing, high compression, stream control accurate, stable, support dual stream
1/2.8" SONY Starvis CMOS Sensor, 2MP
10X Optics zoom, auto zoom function
Built-in automatic day and night dual filter switching mechanism, with manual or automatic color toblack and other switching methods
support dual stream
Support network disconnect, motion detection, Video masking, intelligent out off focus alarm
Smart coding
Up to 4 ROI area,
abundant network protocol
2.0MP/1920*1080@25FPS
D-WDR, 3D noise reduction
ONVIF2.4, GBT28181
Model | IP16DS291D-AZ0550 |
IP camera | |
Image sensor | 1/2.8-lnch 2MP IMX291 |
CPU | HISILICON Hi3516D |
Effective pixels | 1920(H)x 1080(V) |
Scan system | Progressive |
Electronic shutter | 1/25s~1/10000s |
Min illuminator | Color:0.001Lux@F1.2 |
S/N ratio | ≥50dB(AGC OFF) |
IR CUT | ICR |
WDR | > 80dB |
Noise reduction | > 3D reduction |
Privacy masking | UP to 4 area |
Lens type | 10X automatic zoom lens,YTOT5-50mm |
Video | |
Coding | H.265/H264/MJPEG |
Main stream | 1080P(1920x1080)\1280*720 |
Sub stream | D1(704x576)/VGA(640*480)/QVGA(320x240) |
Video frame | 1 ~ 25fps (50HZ) 1 ~ 30fps (60HZ) |
Video bit ratio | 32KB ~ 16Mbps |
Picture setting | brightness, Contrast, saturation, sharpness, BLC AWB, AGC, AE are adjustable, support privacy masking OSD Image eversion 90°/ 270°, ICR Switch auto or manual are optional |
Smart function | |
Smart coding | Support low bit rate, low latency, enhanced coding of ROI area, up to 4 ROI area |
Smart detection | Support intelligent masking detection ,intelligent out off focus detection |
Smart control | Support smart control alarm open, alarm shut, fault clear, smart noise reduction |
Network | |
Network interface | 10M/100M |
Network protocol | IPv4, HTTP, TCP/IP, UDP, RTP, RTCP, UPSP, RTSP, SMTP, NTP, DHCP, DNS, PPPOE, DDNS, FTP |
Access standard | ONVIF/GB28181 |
Client user | Up to 8 user at same time |
Smart phone | iphone, ipap, Android |
General parameters | |
Power | DC 12V |
Consumption | 2W(MAX) |
Temperature, humidity | -10°C~55°C,20-80%RH |
Size | 38X38X85mm |
![]() | ![]() |
![]() | ![]() |
This product not include cable by default.
JP1 Power interface | Preview | Pitch | |
1 | DC12V | ![]() | 1.25mm |
2 | Video GND | ||
3 | CVBS output | ||
4 | GND | ||
JE1 Network interface | 1.25mm | ||
1 | RJ45_1 (TX+) | ||
2 | RJ45_2 (TX-) | ||
3 | RJ45_3 (RX+) | ||
4 | RJ45_6 (RX-) | ||
5 | Network connection indicator light (green light) | ||
6 | Network status indicator light (yellow light) | ||
Sensor board J1 IR-cut interface | 1.25mm | ||
1 | IR-CUT control signal 5V- | ||
2 | IR-CUT control signal 5V+ | ||
Sensor board J2 DC auto Iris interface (Support automatic aperture model: -AI) | Depend on color definition of Lens | 1.25mm | |
1 | drive- | ||
2 | damp- | ||
3 | drive+ | ||
4 | damp+ | ||
Sensor board J3 Power Auto Zoom lens interface (Support Electric lens model:-AZ) | Depend on color definition of Lens | 1.25mm | |
1 | Focus A- | ||
2 | Focus A+ | ||
3 | Zoom A- | ||
4 | Zoom A+ | ||
5 | Zoom B+ | ||
6 | Zoom B- | ||
7 | Focus B- | ||
8 | Focus B+ | ||
Sensor board J4 No definition | |||
J5 Infrared Light board interface | 1.25mm | ||
1 | Infrared Light board12V power output | ||
2 | GND | ||
3 | LED feedback signal input(0.8V-12V) | ||
4 | Infrared Light enable control | ||
J6 function interface | Support powerless microphone and Line in | 1.25mm | |
1 | Audio in | ||
2 | Audio GND | ||
3 | Audio out | ||
4 | GND | ||
5 | Reset | ||
6 | Alarm in 1, low level effective | ||
7 | Alarm in 2 (reserve), low level effective | ||
8 | Alarm out control GPO, 3.3V level signal | ||
9 | RS_485+ | ||
10 | RS_485- | ||
JU1 USB interface | Support MT7601 /RT5370 USB wifi module. | 1.25mm | |
1 | GND | ||
2 | USB_DP | ||
3 | USB_DM | ||
4 | 5V power out | ||
J7 expandion board | FPC | ||
1 | USB_DP | ||
2 | USB_DM | ||
3 | System | ||
4 | SDIO Work Clock | ||
5 | SDIO Data3 | ||
6 | SDIO Data2 | ||
7 | SDIO Data1 | ||
8 | SDIO Data 0 | ||
9 | System | ||
10 | SDIO Order | ||
11 | SDIO Power enable control signal | ||
12 | SDIO Card detection signal | ||
13 | SDIO Pull-up resistor power out | ||
14 | Alarm out control GPO | ||
15 | System | ||
16 | DC5V Power out |